Page 1 of 1
What is the better Outgoing list settings? Default settings?
Posted: Thu Nov 12, 2009 11:36 am
by S_Flash
Better use default Outgoing list settings or ..?
Re: What is the better Outgoing list settings? Default settings?
Posted: Thu Nov 12, 2009 9:00 pm
by texpert
Hi,
version 2.x has an automatic outgoing list feature implemented and it is enabled by default, it works good. But if you have some individual requirements, you can also override the automatic outgoing list config. You can read how to do that and what difference does it make in the manual, "options / general / outgoing" topic.
regards,
Jim
Re: What is the better Outgoing list settings? Default settings?
Posted: Fri Nov 13, 2009 9:07 am
by S_Flash
texpert wrote:Hi,
version 2.x has an automatic outgoing list feature implemented and it is enabled by default, it works good. But if you have some individual requirements, you can also override the automatic outgoing list config. You can read how to do that and what difference does it make in the manual, "options / general / outgoing" topic.
regards,
Jim
Im not sure I use a right Outgoing list (OL) settings, because I use TE 2.x updated from 1.x and with edited OL...
How to check default OL settings?
Re: What is the better Outgoing list settings? Default settings?
Posted: Fri Nov 13, 2009 9:20 am
by S_Flash
Found!
All ok!
Re: What is the better Outgoing list settings? Default settings?
Posted: Fri Nov 13, 2009 1:04 pm
by texpert
Basically you go to "options / general / outgoing list" and set "mode" parameter to "automatic". Automatically generated outlist will appear on the screen.
regards,
Jim