Trade Expert Support Forum

Hello, i think that raw ratio of single traffic feeder account is 0, but the total raw ratio of traders is calcuated wrong, it considers also traffic from feeder, and this will be a problem for dynamic skim setting.
What do you think ? am i wrong ?
Thx
jimba

Hi mate,

Ratio Raw = Out T / Raw and it should work fine, but
send me a PM with login details for your TE and tell me exactly what do i have to take a look at.

regards,
Jim

Hey dude,
did u check PM ?

Check your PM, i've sent u my current IP so u can add to your TE access list, because i can't login.

best regards,
Jim

Hm ratio raw is being calculated like this:
Ratio Raw = Out T / Raw

for each individual trade and summary as well.
Since Out T for traffic holder (feeder) is 0 ,the calculation is 0 / Raw which we simply display as 0.

For the summary, we take the data from the summary row and calculate ratio raw based on that. I guess this is what's confusing you... i think it's nothing wrong here.

Hope this answered your question,

best regards,
Jim

I think that Feeder traffic should not affect raw ratio summary, cause it will have effect on dynamic skim settings.

If i'm not wrong, summary ratio is calculated in this way:
Summary Ratio Raw = Summary Out T / Summary Raw (Summary Raw considers also the Raw traffic from feeder)
That means more traffic i will get from feeder, lower summary ratio i will get, and dynamic skim ratio setting should be updated every time.

Am I right ?

Traffic from your feeder is being tracked as incoming and clicks, since you don't send feeders outgoings back, "Out T" for any feeder is zero. Clicks produced by the feeder traffic is distributed between your trades, meaning while "Out T" summary for feeder is showing 0, that traffic is distributed between your trades ( Out T ) and therefore Ratio Raw should keep in balance unless you purchase a huge amount of unproductive feeder traffic (large amount of incoming raws and small amount of clicks => Out Ts for your trades).

regards,
Jim